ESP32 firmware engineering for ESP-IDF projects. Write, review, and debug embedded C/C++ code involving FreeRTOS tasks/queues/timers, GPIO/I2C/SPI/UART/ADC/PWM peripherals, TWAI/CAN, Wi-Fi/BLE networking, OTA updates, Secure Boot and flash encryption, LVGL display integration, build/flash/monitor workflows, logging, crash analysis, memory/code-size optimization, low-power sleep/wakeup design, on-device USB/serial service terminals, and board bring-up. Use when an agent is asked to implement ESP-IDF firmware features, review embedded changes for correctness or race conditions, investigate boot/runtime failures or Guru Meditation panics, interpret serial logs, fix build/link/flash problems, optimize RAM/flash usage, tune deep sleep/light sleep behavior, harden firmware for production, add a service console/CLI, integrate a display with LVGL, or diagnose hardware-software integration issues on ESP32-class devices.
Inicia sesión para votar.
New here? These commands run inside Claude Code, Anthropic's terminal-based coding assistant — not your regular shell. Open a terminal, type claude to start a session, then paste the two lines below inside it.
npx skills add adamlipecz/esp32-firmware-engineer-skill --skill "esp32-firmware-engineer" -a claude-code -g -yPaste into a Claude Code session. This only adds/installs the plugin — nothing runs automatically.
O, si ya vinculaste skillcat-sync, envíalo directamente — te pedirá confirmar antes de tocar nada.
This listing is sourced from adamlipecz/esp32-firmware-engineer-skill. The security badge above comes from a third-party audit (skills.sh) — we haven't independently executed or reviewed this code ourselves. Review the source before installing.
¿Eres el autor y quieres corregir algo de este listado, o pedir que lo quitemos? Escribe a autores@skillcat.es.